DO NOT use a wrench on the Gas Control body, damage to the Gas Control may occur. Install new Gas Control into the water heater by rotating clockwise. Read also: Bradford White Electric Water Heater Reset Button Location Revealed Procedure to remove gas controlįollow steps 1 – 5 given above and then disconnect main burner feedline, pilot tube, piezo igniter wire, inner red door wire and white thermocouple wireī) Remove Gas Control from water heater by rotating counter clockwise.Pilot light button not being fully Procedure to install a new gas control Be careful not to damage gasket material on inner door Remove the right side inner door and set aside.Remove 2 hex drive screws from FLANGE SECTION of inner door.Remove 2 hex drive screws from the RIGHT side inner door.Disconnect red wire leads from resettable thermal switch.Remove the outer jacket burner access door. Turn off the water supply and drain the water heater completely.Disconnect gas supply line from Gas Control.Turn off the gas supply to the water heater.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |